Alamo GR60 Instrukcja Użytkownika Pobierz pdf (Strona 123)

OPERATION

GR60/72 02/07 Operation Section 4-41

OPERATION

Problem Possible Cause Remedy

Blades Wear Fast Cutting in sandy or rocky conditions Increase cutting height.

Blades too soft. Replace Blades with hardened,

high-quality, Rhino Blades from the

manufacturer.

Blade Bolts Working Loose Bolts not tightened. Tighten Bolts to 300 ft./lbs.

Bolt hole elongated or oversized. Replace Blade Carrier.

Locknut worn out. Replace Locknut.

Broken Cross or Cups Load too high for joint. Use protective device with joint.

Check joint angles and phasing.

Slow down ground speed or raise

Mower.

End Galling of Cross and Cups Speed too high. Reduce speed to 540 RPM.

Ears have deformed. Install thrust washer.

Needle Rollers Have Brinelled Load too high for joint. Check for small joint angles.

Into Cup and Cross Use Slip Clutch.

Check joint angles and phasing.

Shaft or Tube Twisted Over-loaded. Replace part and then slow down

ground speed or raise Mower.

Use protective device.

(See Clutch Maintenance).

Tube Broken in Welded Seam Over-loaded. Replace part.

(See Clutch Maintenance).

Yoke Broken at Ear Tip Over-loaded. Replace part.

Gearbox Noisy Improper backlash. Refer to Maintenance Section.

Rough gears. Run in or change Gears.

Worn Bearing. Replace Bearing.

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 145 146

Brak uwag

Alamo GR60 Instrukcja Użytkownika Strona 123