Alamo SR14 Instrukcja Użytkownika Pobierz pdf (Strona 149)

MAINTENANCE

SR20M/SR14M 06/98 Maintenance Section 5-19

FIGURE 40 FIGURE 41

STEP 3

Apply some Locktite on the Adjusting Nut FIGURE 38. Install the Adjusting Nut onto the Shaft FIGURE 39. Tighten

the Nut until it is difficult to turn the Shaft FIGURE 40. While holding Hub, tap each end of the Shaft and check to

see if it has loosened. Repeat this process until the Shaft no longer becomes loose in the assembly. Unscrew the

Nut a small amount and again tap each end of Shaft while holding the Hub. Repeat this process until a rolling

torque of 10 to 12 inch pounds is reached on the Shaft. Install Cotter Pin FIGURE 41making sure it does no Bend

over the end of the shaft.

FIGURE 39FIGURE 38

1 2 ... 144 145 146 147 148 149 150 151 152 153 154 ... 165 166

Brak uwag

Alamo SR14 Instrukcja Użytkownika Strona 149