Alamo TW84 Instrukcja Użytkownika Pobierz pdf (Strona 136)

OPERATION

TW84 03/07 Operation Section 4-44

OPERATION

Blades on upside down. Turn Blades right side up and tighten.

CUTTER WINDROWING Cutting heavy material. Raise mower and reduce

ground speed.

BROKEN CROSS OR Load too high for joint. Use protective device with joint.

CUPS Check joint angles and phasing.

Slow down or raise Mower.

(See Clutch Maintenance)

END GALLING OF Speed too high. Reduce speed to rated RPM speed.

CROSS AND CUPS

NEEDLE ROLLERS Load too high for joint. Check for small joint angles.

HAVE BRINELLED Use protective device.

INTO CUP AND CROSS Check joint angles and phasing.

SHAFT OR TUBE TWISTED Over-loaded. Replace part and then slow down or

or raise Mower. Use protective device.

TUBE BROKEN IN WELDED Over-loaded. Replace part.

SEAM

YOKE BROKEN AT Over-loaded. Replace part.

EAR TIP

SLIP CLUTCH SLIPPING Excessive load. Reduce speed and/or raise cutter.

EXCESSIVELY

Springs weak. Replace Springs.

Improper adjustment. Re-adjust Slip Clutch

Too much power for Reduce ground speed and

Slip Clutch. material intake.

Friction Facings worn. Replace Facings.

Oil on Facings. Replace Facings.

Friction Facings glazed. Clean with emery cloth.

OIL BLOWING OUT Flat bottomed Vent Plug Replace with proper Vent Plug.

VENT PLUG or shallow cavity Plug. Cavity in Oil Plug should be

approximately 5/8".

Oil level too high. Lower oil level to Plug.

DRIVELINE INTEGRAL Integral Shields deformed. Replace Shield.

SHIELDS RATTLING OR

NOT TURNING FREELY Nylon Bearing worn. Replace Nylon Bearing.

1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 153 154

Brak uwag

Alamo TW84 Instrukcja Użytkownika Strona 136